Asin: B0040VGKJU
Product brand: Chip Quik
Product category: Brazing Equipment
Product rating:4.0
anyone visit this site using keywords and phrases CHIP QUIK® No Clean Flux in Squeeze tubes
Hi guest, I am hoping today is your fortunate day. Currently I will cover the actual CHIP QUIK® No Clean Flux in Squeeze tubes, it is a well-liked product with this calendar month. Most people are trying to find by means of search engines to get CHIP QUIK® No Clean Flux in Squeeze tubes in the best deal. The good thing is that we know over it and definitely will inform you to getCHIP QUIK® No Clean Flux in Squeeze tubes (Black) at the best deal with the trusted online shop in the usa.
Description : CHIP QUIK® SMD-291 Tack Flux 6 Pac - Squeeze Tubes - No Clean
Features :
- Packaged in 6 convenient 2 cc squeeze tubes
- The same flux used in CHIP QUIK® SMD-1
- No messy syringe, easy to use
Treasurer testimonials a number of purchasers:>>
Chip Quik Solder Flux
The Chip Quik Solder Flux works fine, but it "burns" rather quickly. After a few seconds of applied heat, the flux seems to "scoot away" from the heat source and turn brown. Once it turns brown, it becomes very gummy and is difficult to remove either with hot soap and water OR denatured ethanol (ethyl alcohol).
I have also used Kester 2331-zx flux "thickened" by allowing the solvent to evaporate. The Kester flux works much better. It doesn't burn, and it washes off with hot water even if it's been heated "a lot".
The Chip Quik flux is "tacky" - the purpose being to hold an SMD part in place while it's being soldered. Unfortunately, the flux viscosity goes way down when it gets hot and it doesn't hold a part down. A small SMD part, heated on one side only, will "tombstone" (pop up vertically and solder to one end only).
The part needs to be held down while soldering to prevent this. Of course, this is inherent in all flux formulations... the Kester flux...
No comments:
Post a Comment