Warner Linear K2G20-12v-BR-18 B-Track K2 18" Stroke Length Rugged Duty Actuator Big SALE

Title: Warner Linear K2G20-12v-BR-18 B-Track K2 18" Stroke Length Rugged Duty Actuator
Asin: B003XT6B2G
Product brand: Warner Linear
Product category: Linear Motion Actuators
Product rating:3.0
you check out this excellent website with key phrases Warner Linear K2G20-12v-BR-18 B-Track K2 18" Stroke Length Rugged Duty Actuator

Hi there visitor, I really hope right now is your lucky moment. At the moment I am going to tell you about the Warner Linear K2G20-12v-BR-18 B-Track K2 18" Stroke Length Rugged Duty Actuator, this can be a well-known product with this calendar month. Many people are seeking via search engines like yahoo to buy Warner Linear K2G20-12v-BR-18 B-Track K2 18" Stroke Length Rugged Duty Actuator on the best deal. The good news is that we all know over it and definitely will let you know to buyWarner Linear K2G20-12v-BR-18 B-Track K2 18" Stroke Length Rugged Duty Actuator (Black) at the lowest price in the reliable online store in the usa.

Description : Warner Linear Rugged Duty Actuator with 20:01 Gear ration, 12V motor, Bronze nut, and 18 inch stroke length. Unit has standard base fitting.
Features :

• Maintenance Free
• Long-Life Service
• 12 volt
• 20 to 1 gear ratio
• 18" stroke

Treasurer opinions several potential buyers:>>
Direct replacement for Searay 340DA 2000 Hatch Actuator
My old hatch actuator was getting slow and eventually started blowing the 20Amp dash panel fuse - a web search turned up this unit as the "updated" version since Warner has been sold and the 1999/2000 unit is long obsolete. Replaced with this new unit and it now runs up and down without any trouble. If replacing the Searay 340DA 2000 installation, you will need the 5" extension on the end of the old unit, so do not discard that. I cut the supplied connector off and just used yellow shrink-tube butt connectors (boat wiring is larger than motor wiring so you could use step-down yellow/blue connectors but I just double the smaller guage over the larger and crimp them together on one side of the butt connector - then use a larger black shrinktube over that with a heat gun to wrap this up - then wire-tie and you're done with electricals. Easy install, 20 minutes upside down over the port engine to complete wiring and 10 minutes in the bilge for mechanicals - basically 3 bolts - sockets...